20150120_173304

Today, we set some deadlines for fabrication and tried to get as far as possible for milling and lathing. The biggest challenge has been Mastercamming the chassis sides as they are too big to fit in the mill at once. These parts require a lot of programming and knowledge to complete. Our deadline for fabrication to be done is next Tuesday so we hope to accomplish this goal.

20150120_173438

In other areas of our team, design has mostly finished the CAD and is adding weight reduction, as our robot is very close to the weight limit. Design has gone well overall and we have mostly moved on to fabrication.

IMG_1573

Programming has not only been programming the robots autonomous but has been working on our electronic attendance as well as our part tracking system that sadly has not been implemented yet. The season is going well and we are mostly on track but the challenge will be to keep this going until the robot is finished.

~Tayloe Bowers

Post a Comment

Your email address will not be published. Required fields are marked *

*